Hook up high level input amp Please turn JavaScript on and reload the page.

Hook up high level input amp

I agree with using a line output converter. The time now is Did you find any sound improvement after changing to Preamp out instead of using speaker level? That sounds like an older MTX.

Make money promoting dating sites

I am splicing off the rear deck speakers and going to speaker level inputs on the amp I am installing. It can result in some very costly damage. Fortunately or so I thoughtthe Profile California amplifier accepts speaker-level input.

Radiocarbon dating dating

Then use the preamp level inputs. It's a 2-channel amplifier that can be bridged to a mono output.

Hook up am loop antenna

Chieh Cheng Tue, 18 Mar I have a 12" Pioneer TSW sub watts rms 4ohm that was used in my old car for about a month before the cheap amp gave out. Kwok Sat, 22 May Denis Vandale Fri, 07 Oct With most head unit that I knowthe a main amp are normally single ended as opposed to bridge. I guess this way, if you burn out the line level converter, your amp still works.

Speed dating sedona

Frequently Asked Questions Did you forget your hook How do I connecting speaker signals to line level input? Taking Hook up software to the next level By subachad in forum General Amp. Adding an amp to stock headunit using high level inputs.

Adding an amp to stock headunit using high level inputs

Read the Forums FAQ. Send a private message to honder.

Brutally honest online dating profile

BB code is On. So any 12v source will work?

Speed dating las vegas nv

Search this Thread Advanced Search. Please consider donating to help us continue to serve you.

Car Stereo Pit Fall #1 - Never Use Speaker Level Input on Amplifier

Underdrive pulleys are input Only take the positive wires from each speaker, and use a chassis ground for the ground connection. Because when I finally did put in a custom head-unit with preamp out, I was too lazy to pull the RCA preamp cable. I think it was about the high level. Connect the speakers directly to the output of the booster amp, do not connect them or even make contact with the body chassis of the car as most amp are design with a bridge amp and this means both the positive and negative output of the amp are active, may not be applicable to you but just a precaution.